Dell C7008 Installing page 48

Step Task (continued)
Extend the left and right card levers by first pressing gently down on the thumb tabs (see
2
ejector levers and then pulling the ejector levers simultaneously until they are in the open position. See
Figure 10-3.
Figure 10-2. Depress the thumb tabs
Figure 10-3. Extend the levers
Pull the card by the card levers until it is out of the slot. Avoid touching the printed circuit board and connector
3
pins.
If you are not replacing the card immediately, install a blank panel.
4
If you are replacing the card, follow the instructions in
5
Removing and Replacing an RPM
WARNING: After removing an RPM, place a panel blank in the empty slot before powering up the chassis.
Blanks are required to control airflow and electromagnetic interference.
NOTE: The C7008/C300 requires at least one RPM to operate. The chassis powers down if you remove the
only RPM.
48 | Removing and Replacing Components
Installing the RPMs and Line
Figure 10-2) in the
Cards.