Dell C7008 Installing page 57

Command
show interface management
ethernet
interface management ethernet ip
ip-address ip-address-mask
address
boot zero {primary | secondary |
default}
reload
Refer to the C-Series Dell Networking OS Command Line Reference for BOOT_USER mode commands
and commands for run-time modes.
Purpose (continued)
• Use the show interface management ethernet command to display
the IP address and network mask of the Management Ethernet port.
• If the show command output does not display configured IP address
information, use the interface management ethernet ip address
address ip-address-mask
Management Ethernet port for network (ftp/tftp) operating system boot.
Use CIDR block notation for the subnet mask,
Delete the boot configuration.
Reload the software.
The autoboot program initializes and displays self-test results on the console
screen.
NOTE:
Do not press the break control sequence at any time during
the boot/reboot process. Doing so causes the boot process to terminate.
command to set the IP address of the
ip-
System Boot | 57