Table of Contents
Advertisement
Step
Task
Rotate the levers towards the card to seat the backplane connectors and line card in place. Push on the knurled
5
section of the levers until the thumb tabs pop up and lock the unit in place. See
Figure 5-3. Close the levers
Figure 5-4. Press the knurled section of the lever
NOTE:
below it when that card is inserted.
Install a blank panel in all slots that do not have a card and secure it with the screws provided.
6
NOTE:
blank panels are installed in the correct slots.
22
|
Installing RPMs and Line Cards
Installing a card without fully engaging the locking mechanism will damage the EMI seal on the card
The blank panels for RPMs and line cards are different sizes (RPM blanks are smaller); be sure that
Figure 5-3
and
Figure 5-4.
Advertisement
Table of Contents
