Dell C7008 Installing page 49

To remove and replace a C7008/C300 RPM:
Step Task
Unplug any network interface cables connected to the RPM.
1
Extend the left and right card levers by first pressing gently down on the thumb tabs (see
2
ejector levers and then pulling the ejector levers simultaneously until they are in the open position. See
Figure 10-5.
Figure 10-4. Depress the thumb tabs
Figure 10-5. Extend the levers
Pull the card by the card levers until it is out of the slot. Avoid touching the printed circuit board and connector
3
pins.
If you are not replacing the RPM, insert an RPM blank panel.
4
If you are replacing the RPM, follow the instructions in
5
Only after the replacement is installed, power up the chassis.
6
Installing the RPMs and Line
Removing and Replacing Components
Figure 10-4) in the
Cards.
| 49