Touchscreen
Adjusting the Display Backlight Timer
Start | Settings | System | Backlight
The backlight settings use the Honeywell set of default timeouts.
When the backlight timer expires, the display backlight is dimmed, not turned off. When both checkboxes are unchecked, the
backlight never turns off (or dims).
Default values are 3 seconds for Battery, 2 minutes for External and both the check boxes are enabled.
Apply the Touchscreen Protective Film
First,
clean the touchscreen
Remove the protective film from its container. Remove any protective backing from the film sheet by lifting the backing from a
corner of the film. Discard the backing.
Apply the film to the touchscreen starting at one side and smoothing it across the display. If air bubbles appear, raise the film
slightly and continue smoothing the film across the display until it covers the glass surface of the display. If dust, lint or
smudges are trapped between the protective film and the glass display, remove the protective film, clean the display and apply
the protective film again.
Contact your
representative
Calibrating the Touchscreen
If the touchscreen is not responding to any touch,
Press Ctrl + Blue + Alt to force the Start Menu to appear.
l
Use the down arrow to select Settings and press Enter.
l
Use Tab to go to the tab titles.
l
Use Blue + Up Arrow to go to System.
l
Use Down Arrow and right arrow (Blue + Up Arrow) to select Screen and press Enter.
l
Press Enter to execute and Enter again to begin alignment.
l
If the touchscreen is not responding properly to stylus taps, you may need to recalibrate the touchscreen.
Recalibration involves tapping the center of a target. If you miss the center, keep the stylus on the screen, slide it over the
target's center, and then lift the stylus.
To recalibrate the screen, select Start | Settings | System | Screen tab.
To begin, tap the Align Screen button on the screen with the stylus.
Follow the instructions on the screen. Tap the OK button when complete, if necessary.
of fingerprints, lint particles, dust and smudges.
about protective film packs designed specifically for your MX8 touchscreen.
2-7