Advertisement
21. Install the A/C wire harness.
With Fog Lights:
FOG LIGHT
HARNESS
Connect the vehicle harness 4P
connector to the A/C harness
4P connector, then snap the
connector into the bracket.
Snap this
wire harness
clip into the
hole next to
the ground
bolt.
Connect the A/C
harness pressure
switch connector
to the receiver.
2002 American Honda Motor Co., Inc – All Rights Reserved
Secure the A/C wire
harness to the fog
light wire harness
with two wire ties
(38221-SW5-300).
Cut off the excess
wire tie.
FRONT
Attach the A/C harness
ground terminal here with the
ground bolt (gold-colored),
90153-SE0-003. Torque the
bolt to 10 N
(7 lb-ft).
Without Fog Lights:
Attach the A/C wire harness to
the front bulkhead by snapping
the two wire harness clips into
the two holes shown.
FRONT
.
m
Connect the
A/C harness 3P
connector to the
compressor, then
snap the connector
to the bracket into
the condenser fan
shroud.
AII 24158 (0209)
Connect this 2P
connector of the A/C wire
harness to the condenser
fan connector.
Remove the blue tape from
the vehicle harness 4P
connector, then remove and
discard the blank connector.
Snap this wire
harness clip
into the tab on
the condenser
fan shroud.
Attach the
compressor
harness clip to
this tab on the
condenser fan
shroud.
19 of 24
Advertisement
