Advertisement
23. Reinstall the power steering pump.
Reinstall the P/S
hose in the bracket.
Reinstall the adjusting
bolt, and turn it by hand
to get the proper belt
tension of 390 to 540 N
(40 to 50 kg).
Do not overtighten!
24. Install the A/C suction line and receiver line B.
Connect the A/C suction
line and receiver line B
to the evaporator with
one 6 x 30 mm flange
bolt (yellow-tinted),
95701-06030-08, and
two 6 mm paint-cutting
nuts (yellow-tinted),
90361-SV4-003. Torque
the bolt and nuts to
.
10 N
m (7 lb-ft).
HEATER
VALVE
CABLE
2002 American Honda Motor Co., Inc – All Rights Reserved
Reinstall the P/S pump
Torque the two
and its mounting bolts
mounting nuts to
and nuts. Do not tighten
.
24 N
m (17 lb-ft),
the bolts and nuts yet.
then recheck the
belt tension.
THROTTLE
CABLE
Slide the A/C suction line and receiver line B clamp onto
the mounting stud. Make sure that the throttle and heater
cables are not caught or pinched by the bracket, then
install a 6 mm paint-cutting nut (yellow-tinted),
90361-SV4-003. Torque the nut to 10 N
Reinstall the P/S fluid reservoir
back in its mounting bracket.
Reinstall the P/S belt.
Make sure the belt is
properly aligned in the
grooves of the pulleys.
Push the brake booster vacuum hose toward the
engine, then feed the suction hose on the A/C
suction line and receiver line B under it.
A/C LINE B
Reinstall the brake booster
hose clamp into the square
hole on the bulkhead, then
snap A/C line B into it.
.
m (7 lb-ft).
AII 24158 (0209)
Fit the belt tension gauge
(T/N 07JGG-01010A) onto
the P/S belt.
Do not use any other
gauge!
21 of 24
Advertisement
