Advertisement
19. Install the condenser and receiver lines.
Secure the condenser line to
the receiver with one 6 x 25
mm flange bolt (yellow-tinted),
95701-06025-08. Torque the
.
bolt to 10 N
m (7 lb-ft).
FRONT
Apply refrigerant
oil to both fittings on
the condenser line,
then install the line
between the receiver
and condenser.
20. Install the compressor and the condenser fan.
Install the compressor on the
compressor bracket with the
four 8 x 100 mm flange bolts
(90023-P2A-000). Torque
.
the bolts to 24 N
m (17lb-ft).
18 of 24
Install receiver line clip A
(80381-S5A-A01) into
this square hole.
Secure the condenser
line to the condenser
with one 6 x 25 mm
flange bolt (yellow-tinted),
95701-06025-08. Torque
.
the bolt to 10 N
m (7 lb-ft).
AII 24158 (0209)
Install receiver
line clip B
(80387-SM4-A01)
into this square
hole.
Apply refrigerant oil
to its fitting, then
connect the receiver
line to the receiver
with one 6 x 25 mm
flange bolt
(yellow-tinted),
95701-06025-08.
Torque the bolt to
.
10 N
m (7 lb-ft).
Secure the
condenser fan
assembly with two
6 x 16 mm washer-
bolts (gray-colored),
Carefully set the
93403-06016-05.
condenser fan
Torque the bolts to
assembly in place
10 N
on the condenser
fan mounts.
2002 American Honda Motor Co., Inc – All Rights Reserved
.
m (7 lb-ft).
Advertisement
