Advertisement
---
1988
.:. 1990
HONDA
CIV~C
(with
1.5 L engine
)
Throttle
Lever
Adap~9~
P~~kage
(Model
Z)
..-'-250::.~197
Throttle
Connection
The Cruise Control Cable attaches to the Bracket. Throttle
Lever provided in the adaptor package.
'.
STEP 1
.Remove
nut and lock washer from passenger's side ofThrottle
Shaft. Install Bracket-
Throttle
Lever.
Reinstall lock washer and nut, retighten to 7:.10 ft.lbs.
NOTE;
B.e,~~feful not.to cross thread the nut when retightening.
STEP 2
Fabricate Bracket-Cable from one of the brackets provided in the basic kit using the
te~plateo~the
reverse side ot~his sheet.
STEP 3
Install Bracket-Cable
to cam cover and attach Cruise Control Cable with 'Tube"
clilmps;as shown in Figure HOO1.
.
STEP 4
Attach.Bead Chain, Eyelet Connector, and Bead Chain Connector Cover, to the
B;racket- Throttle Lever; and install washer and cotter pin as shown in Figure HOO2.
)1
,~
For'm 2274 Rev:A
2/95
All
RIGHTS
RESERVED
PRINTED
IN THE USA
Advertisement
Table of Contents
Related Manuals for Honda 250-4197
Summary of Contents for Honda 250-4197
- Page 1 1988 .:. 1990 Throttle Throttle Connection The Cruise Control Cable attaches to the Bracket. Throttle STEP 1 .Remove nut and lock washer from passenger's side ofThrottle Throttle Lever. NOTE; B.e,~~feful not.to cross thread the nut when retightening. STEP 2 Fabricate Bracket-Cable from one of the brackets provided in the basic kit using the te~plateo~the STEP 3 Install Bracket-Cable...
- Page 2 Discard Enlarge to 5/16" Brack.et provided in Basic Cruise Control Kit...
Need help?
Do you have a question about the 250-4197 and is the answer not in the manual?
Questions and answers