Advertisement
25. Connect the suction line.
Install the suction hose
bracket to the P/S hose
bracket with a 6 x 12 mm
washer-bolt (yellow-tinted),
93403-06012-08. Torque the
.
bolt to 10 N
m (7 lb-ft).
26. Install the discharge hose.
COMPRESSOR
CLUTCH WIRE
Route the discharge
hose below the
compressor clutch
wire, and up to the
compressor.
Remove and retain this 6 mm
flange nut, then remove and
discard the cap from the
compressor.
22 of 24
.
Torque this fitting to 33 N
m
(24 lb-ft). Make sure you
use a second wrench to
hold the other fitting.
P/S HOSE
BRACKET
Install the suction hose
clamp onto the suction hose
bracket, then secure the
suction hose in the clamp.
SUCTION LINE
SUCTION PIPE
Install the suction line bracket with two
6 x 16 mm washer-bolts (gray-colored),
93403-06016-05. Torque the bolts to
.
10 N
m (7 lb-ft).
Apply refrigerant oil to its O-ring, then
connect the discharge hose to the
condensor with a 6 x 25 mm flange bolt
(yellow-tinted), 95701-06025-08. Torque
the nut to 10 N
Apply refrigerant oil to its O-ring, then connect the
discharge hose to the compressor with the retained
6 mm flange nut. Torque the nut to 10 N
AII 24158 (0209)
Apply refrigerant oil to the
suction hose O-ring, then
loosely connect the suction
hose to the suction line.
Apply refrigerant oil to its O-ring,
then connect the suction line to the
compressor with the retained 6 mm
flange nut. Torque the nut to 10 N
(7 lb-ft).
Remove and retain this 6 mm
flange nut, then remove and
discard the cap from the
suction side of the compressor.
.
m (7 lb-ft).
.
m (7 lb-ft).
2002 American Honda Motor Co., Inc – All Rights Reserved
.
m
Advertisement
