Seat Alhambra Owner's Manual page 219

Caution
•
Other additives may give considerably inferior corrosion protection. The
resulting corrosion in the cooling system can lead to a loss of coolant,
causing serious damage to the engine.
•
The coolant additive G 12+ (purple) can be mixed with the additive G 12
(red) or G 11. Never mix G12 (red colour) with G 11.
Checking the coolant level and topping up
The correct coolant level is important for fault-free func-
tioning of the engine cooling system.
Before opening the bonnet, read and observe the warnings ⇒
"Safety instructions on working in the engine compartment" on
page 209.
Safety First

Fig. 142 In the engine
compartment: Coolant
expansion tank cap
Operating instructions
Opening the coolant expansion tank
– Switch off the engine and allow it to cool.
– To prevent scalding, cover the cap on the expansion tank with a
thick cloth and carefully unscrew the cap ⇒
Checking coolant level
– Look into the open coolant expansion tank and read off the
coolant level.
– If the level is underneath the "MIN" mark, top up with coolant.
Topping up coolant
– Only use new coolant.
– Do not fill above the "MAX" mark.
Closing the coolant expansion tank
– Screw the cap on again tightly.
The position of the coolant expansion reservoir is shown in the corresponding
engine compartment diagram ⇒ page 262.
Make sure that the coolant meets the required specifications ⇒ page 216.
Do not use a different type of additive if coolant additive G 12+, is not avail-
able. In this case use only water and bring the coolant concentration back up
to the correct level as soon as possible by putting in the specified additive
⇒ page 216.
Always top up with new coolant.
in
Do not fill above the "MAX" mark. Otherwise the excess coolant will be forced
out of the cooling system when the engine is hot.
Tips and Maintenance
Checking and refilling levels
.
Technical Data
217