Table of Contents
Advertisement
MODEL BASIC SETTING PROCEDURE
Airplane/glider basic setting procedure
1. Model addition and selection
Initially, the T14SG assigns the first model to
model-01 in the transmitter. The Model Select
function of the Linkage Menu is used to add
models and to select amongst models which are
already set.
The T14SG is capable of storing data for up
to 30 models in its internal memory. Additional
model data can also be saved to an optional SD
card.
The currently selected model name is displayed
LQ WKH FHQWHU RI WKH KRPH VFUHHQ %HIRUH À\LQJ DQG
before changing any settings, always confirm the
model name.
When a new model is added, the Model type
select screen and System mode setup screen
automatically appear. Please be aware that the
transmitter will stop transmitting temporarily when
you change the model.
When a new model is added, you will need to re-
link the receiver.
2. Model type selection
Select the model type matched to the aircraft
with the Model Type select function of the Linkage
Menu. For an airplane, select the model type from
among the 2 types: airplane and glider. And then
select the wing type and the tail type matched to
the aircraft.
44
<Model Basic Setting Procedure>
3. Fuselage linkage
Connect the ailerons, elevators, throttle, rudder,
etc. in accordance with the model's instruction
manual. For a description of the connection
method, see the Receiver and Servos Connection.
Note that even for the same "airplane
model", when the wing type and tail type
are different, the channel assignment may
be different. (The channel assigned to each
function can be checked at the Function
menu of the Linkage Menu.)
,I WKH GLUHFWLRQ RI WKH VHUYR LV LQFRUUHFW DGMXVW
WKH GLUHFWLRQ ZLWK WKH 5HYHUVH IXQFWLRQ RI WKH
/LQNDJH 0HQX
$GMXVW WKH QHXWUDO SRVLWLRQ DQG FRQWURO
VXUIDFH DQJOH ZLWK WKH OLQNDJH DQG ILQH
WXQH WKHP ZLWK WKH 6XE7ULP DQG (QG 3RLQW
IXQFWLRQV DQJOH DGMXVWPHQW 7R SURWHFW WKH
OLQNDJH D OLPLW SRVLWLRQ FDQ DOVR EH VHW ZLWK
WKH (QG 3RLQW IXQFWLRQ 7KH (QG 3RLQW IXQFWLRQ
FDQ DGMXVW WKH DPRXQW RI XSGRZQ DQG OHIW
ULJKW PRYHPHQW DQG OLPLW RI HDFK FKDQQHO
4. Throttle cut setting (Airplane)
Throttle cut can be performed with one touch by a
switch without changing the throttle trim position.
Set throttle cut with the Throttle Cut function of
the Linkage Menu. After activating the throttle cut
function and selecting the switch, adjust the throttle
position so that the carburetor becomes fully closed.
For safety, the throttle cut function operates the
Advertisement
Table of Contents
