FUTABA 14SG Instruction Manual page 139

When setting a rate selection switch, move
the cursor to the switch item and touch the
RTN button to access the selection screen.
Select the switch and set its ON direction.
$OZD\V 21 DW  VHWWLQJ
*For a description of the switch selection method, see the
description at the back of this manual.
*\UR W\SH VHOHFWLRQ
Move the cursor to the gyro type selection
item and touch the RTN button to switch to
the data input mode. Select the gyro type
by scrolling the touch sensor.
>*<@ :KHQ D )XWDED *<$ J\UR LV XVHG
>1250@ :KHQ XVLQJ VRPHWKLQJ RWKHU WKDQ
)XWDED *<$ J\UR LV XVHG
Touch the RTN button to change the gyro
type and return to the cursor mode.
*When a Futaba GYA gyro is used and [GY] type is selected,
the sensitivity set value is directly read in both the AVCS
and NORM modes.
2SHUDWLRQ PRGH VHOHFWLRQ *<$ J\UR
Move the cursor to the operation mode
([DPSOH 6HWWLQJ WKUHH D[LV XVLQJ D *<$ DQG *<$ 
:LQJ W\SH $LOHURQ  VHUYRV PRXQWHG IXVHODJH VHOHFWHG
6HW *\UR  *<$$,/ &+ *\UR  *<$(/( &+ *\UR  *<$58' &+ DW
WKH )XQFWLRQ PHQX RI WKH /LQNDJH PHQX
5DWH  >2))@>*<@>6(@>1250@> @>1250@> @>1250@> @
5DWH  >,1+@
5DWH  >2))@>*<@>6(@>$9&6@> @>$9&6@> @>$9&6@> @
*Set so that Rate 1 is turned on at the back position of switch E and Rate 3 is turned ON at the front
position. Since switch E is turned OFF at the center, Rate 2 remains [INH].
138 <Model Menu (Airplane/Glider Functions)>
selection item and touch the RTN button
to switch to the data input mode. Select
the operation mode by scrolling the touch
sensor.
>$9&6@ $9&6 PRGH
>1250@ 1RUPDO PRGH
T o u c h t h e R T N b u t t o n t o c h a n g e t h e
operation mode and return to the cursor
mode.
6HQVLWLYLW\ VHWWLQJ
Move the cursor to the sensitivity icon and
touch the RTN button to switch to the data
input mode.
$GMXVW WKH VHQVLWLYLW\ E\ VFUROOLQJ WKH WRXFK
sensor.
,QLWLDO YDOXH 
$GMXVWPHQW UDQJH a
*When the RTN button is touched for one second, the
sensitivity is reset to the initial value.)
Touch the RTN button to return to the cursor
mode.