Table of Contents
Advertisement
V-TAIL
This function enables adjustments for left and
right rudder angle changes during elevator and
rudder operation of a V-tail airplane.
V-tail is when two servos are used together to
control rudder movement as elevators. In addition
to each elevator side moving up and down together,
each side moves in opposite directions when moving
as rudders. On a V-tail, this is also known as a
Ruddervator, as they serve the same purpose.
6HOHFW >97$,/@ DW WKH 0RGHO PHQX DQG
access the setup screen shown below
by touching the RTN button.
6HOHFW WKH IXQFWLRQ QDPH
and return to the Model
menu by touching the
R T N b u t t o n .
O r t h e
H O M E / E X I T b u t t o n i s
pushed.
(OHYDWRU IXQFWLRQ
8S DQG GRZQ WUDYHO DGMXVWPHQW RI
elevator operation
Setting method
7UDYHO DGMXVWPHQW
Move the cursor to the item you want to
DGMXVW DQG WRXFK WKH 571 EXWWRQ WR VZLWFK WR
the data input mode.
$GMXVW WKH UDWH E\ VFUROOLQJ WKH WRXFK VHQVRU
,QLWLDO YDOXH
$GMXVWPHQW UDQJH a
*When the RTN button is touched for one second, the rate is
reset to the initial value.)
Touch the RTN button to return to the cursor
mode.
*If the mixing direction is reversed, adjustments can be made
by changing the mixing rate polarity (+ or -).
*If a large value of travel is specified, when the sticks are
moved at the same time, the controls may bind or run out of
travel. Decrease the travel until no binding occurs.
>&RUUHVSRQGLQJ PRGHO W\SH@ $LUSODQHJOLGHU 9WDLO
<SensorTouch™>
5XGGHU IXQFWLRQ
L e f t a n d r i g h t t r a v e l
D G M X V W P H Q W R I U X G G H U
operation
<Model Menu (Airplane/Glider Functions)>
Scrolling
0RYLQJ FXUVRU
6HOHFWLQJ PRGH
$GMXVWLQJ YDOXH
7R QH[W SDJH
139
Advertisement
Table of Contents
