Table of Contents
Advertisement
GYRO
This function is used when a GYA Series gyro
is used to stabilize the aircraft's attitude. The
sensitivity and operation mode (Normal mode/
AVCS mode) can be changed via a switch.
7KUHH UDWHV 5DWH 5DWH 5DWH FDQ EH
switched.
8S WR D[HV *\UR*\UR *\UR FDQ EH
simultaneously controlled.
6HOHFW >*<52@ DW WKH 0RGHO PHQX DQG
access the setup screen shown below
by touching the RTN button.
6HOHFW WKH IXQFWLRQ QDPH
and return to the Model
menu by touching the
R T N b u t t o n .
O r t h e
H O M E / E X I T b u t t o n i s
pushed.
5 D W H V H W X S
screen selection
* \ U R W \ S H
selection
Setting method
*Prior to using the Function menu in the Linkage menu to
assign the sensitivity channel (Gyro/Gyro2/Gyro3) select an
unused channel.
Set [Control] and [Trim] other than function to [--].
5DWH VHWXS VFUHHQ VHOHFWLRQ
Move the cursor to the setup screen selection
item and touch the RTN button to switch
to the data input mode. Select the setup
screen # by scrolling the touch sensor.
>&RUUHVSRQGLQJ PRGHO W\SH@ $LUSODQHJOLGHU JHQHUDO
>5DWH VHWXS VFUHHQ@
$&7,1+
6ZLWFK VHOHFWLRQ
>5DWH VHWXS VFUHHQ@
>5DWH VHWXS VFUHHQ@
Note: This setting does not assign a sensitivity
channel. To do so, use the Linkage menu
prior to assigning the sensitivity channel
(Gyro/Gyro2/Gyro3), be sure to select an
unused channel.
Set the [Control] and [Trim] settings other than
Function to [--].
(Active rate # display)
<SensorTouch™>
7KH RSHUDWLRQ PRGH $9&6125
and sensitivity of the three axis
*\UR*\UR*\UR FDQ EH VHW
Touch the RTN button to change the setup
screen and return to the cursor mode.
$FWLYDWH WKH IXQFWLRQ
0RYH WKH FXUVRU WR WKH >,1+@ LWHP DQG WRXFK
the RTN button to switch to the data input
PRGH 6HOHFW WKH $&7 PRGH E\ VFUROOLQJ WKH
touch sensor.
*The display blinks.
Touch the RTN button to activate the
function and return to the cursor mode.
<Model Menu (Airplane/Glider Functions)>
Scrolling
0RYLQJ FXUVRU
6HOHFWLQJ PRGH
$GMXVWLQJ YDOXH
7R QH[W SDJH
137
Advertisement
Table of Contents
