Repeater Mode - LEGRAND Wireless access point Configuration Manual

1.6

/ REPEATER MODE

In Repeater mode, you can use the Legrand Access point to extend your wireless
network coverage.
To configure your 802.11 b/g access point in Repeater mode:
1. Click the Repeater tab, the Repeater page is displayed.
2. Select the peripheral device you wish to connect to from the list of available devices on the local
network.
If you cannot find the device you wish to connect to in the list, you can add it. Refer to the "Adding a
peripheral device to the list" section.
3. Click Connect.
To add a peripheral device to the list:
1. When the Adapter tab page is open, click Add. The pop-up window "Add preferred Wireless
Network" appears.
2. Select the appropriate SSID (Service Set IDentifier), a unique identifier attached to the data packets
sent via a wireless network.
3. Select an authentication method:
Open System
Shared System
WPA-Personal
WPA2-Personal
4. Click Connect. The device is now visible in the list.
Point d'accès 802.11b/g
Internet
9