Wireless Remote Battery Replacement Procedure - Sundance Spas Altamar 880 series Owner's Manual

880 SERIES
22.12

Wireless remote Battery replacement Procedure

1. Start by removing the rubber cover to the
remote (Figure A).
2. Turn the remote unit over and locate the battery door
(Figure B).
3. Rotate the battery door, with a coin, counterclockwise
until the dot aligns with the Open arrow (Figure C).
4. Remove battery door using coin to pry the door upward
(Figure D).
5. Replace battery using CR2025 or equivalent (Figure E).
6. Reinstall the battery cover, using the coin to close
(Figure F).
7. Reinstall rubber cover onto remote (Figure G).
Note: Remote unit is water resistant not waterproof,
therefore the unit should be stored in a dry location
within your home and never be left in the spa while
the cover is on and spa is not in use.
Page 78
Fig. A
Fig. B
OPEN CLOSED
Fig. C
OPEN
CLOSED
Fig. D
OPEN CLOSED
Fig. E
OPEN
CLOSED
CR2025
Fig. F
OPEN
CLOSED
Fig. G