Sundance Spas Altamar 880 series Owner's Manual page 64

880 SERIES
Note: This error commonly occurs when the hot tub is first filled because
tap water is often very cold.
Page 58
Circuit board temperature has exceeded acceptable
limit. This message will disappear when the circuit
board temperature drops below acceptable limit. If
condition persists, provide shade for equipment side
of hot tub.
FREEZE PROTECTION
A potential freeze condition has been detected. No
action is required. Jets pump(s) operate until the hot
tub is out of danger.
Communication between the control panel and/or
remote control panel and circuit board is faulty.
Contact your Sundance Spas dealer or qualified
service technician.
WArNiNG: riSk OF HYPerTHerMiA
!
(OVer-HeATiNG) CAUSiNG SeVere
iNjUrY, BUrNS, Or WeLTS.
"WATCHDOG" (hot tub is deactivated). Water
temperature is above acceptable limits. dO NOT
eNTer THe WATer! Remove hot tub cover
to speed cooling. A problem has been detected
which could cause damage to the hot tub or its
components. Contact your Sundance Spas dealer
or qualified service technician.
OPEN SENSOR (heater disabled) or SHORTED
SENSOR (hot tub is deactivated)
The high-limit temperature sensor is non-functional.
This must be repaired only by an Sundance Spas
dealer or qualified service technician.
OPEN or SHORTED SENSOR (heater disabled)
The main temperature sensor is non-functional. This
must be repaired only by an Sundance Spas dealer
or qualified service technician.
CLOSED or SHORTED FLOW SWITCH ON
SYSTEM STARTUP (system disabled) Flow switch
is non-functional. This must be repaired only by an
Sundance Spas dealer or qualified service
technician.