Sundance Spas Altamar 880 series Owner's Manual page 73

7. Adjusting Balance Level
Press EQ button (5) repeatedly until display reads "BALANCE."
Press VOL up/down button (3) to choose desired setting. A display
of "BALANCE R-L" indicates center, L01 to 15 indicates left balance,
R01 to 15 indicates right balance.
Note: Unit returns to volume mode if volume control is not operated for 3
seconds.
8. Adjusting Fader Level
Press EQ button (5) repeatedly until display reads "FADER." Press
VOL up/down button (3) to choose desired setting. A display of
"FADER F-R" indicates center, R01 to 15 indicates rear fade, F01 to
15 indicates front fade.
Note: Unit returns to volume mode if volume control is not operated for 3
seconds.
9. Adjusting Beep Level
Press and hold down EQ button (5) for about 2 seconds until display
reads "BEEP 2ND", then release. Press VOL up/down button (3) to
select either Beep 2ND or Beep on option.
• Select Beep on, you can hear "beep" sound when you press all
buttons.
• Select Been 2ND, you can hear "beep" sound when you press the
button over 1.5 secs.
Note: Unit returns to volume mode if volume control is not operated for 3
seconds.
10. Adjusting i-VOL Level
Press and hold the EQ button (5) for about 2 seconds, then repeat-
edly press until display reads "I-VOL" (Initial Volume Level Adjust-
ment). Press VOL up/down button (3) to choose desired setting (0 to
45) and the I-VOL will be set automatically. This feature regulates the
max volume level during power up. If the volume level is higher than
the initial volume setting when audio unit is turned off, once the audio
unit is switched back on again, the audio unit will keep the volume
adjusted to the preset level. If the volume level is lower than the ini-
tial volume setting when audio unit is turned off, it will remember the
lower level and resume volume at that level when unit is turned on
again.
Note: Unit returns to volume mode if volume control is not operated for 3
seconds.
880 SERIES
Page 67