Storing The Pager Code - Black Box FX810A-R2 Instructions Manual

5.3 Storing the Pager Code

To enter and store a pager code in the Tone Pager or Vibrating/Tone Pager,
follow these steps:
1. Turn the pager OFF.
2. Press and hold the ON/OFF switch, then slide it to the ON position.
Continue holding this switch down until the display shows "=" (about 5
seconds). The display then shows an L, indicating that the pager is ready
to receive a new code.
Figure 5-3. Vibrating/Tone Pager ON/OFF Switch.
Figure 5-2. Tone Pager ON/OFF Switch.
ON OFF
OFF
CAMPUS PAGER
19