Table of Contents
Advertisement
CAMPUS PAGER
You cannot reset either of these codes after you press the PAGE key.
4. Press the PAGE key. The TRANSMIT display lights during transmission,
and the pager's display flashes the message code number 7 times. The
four digits (GROUP is represented as "n" on the display) will remain lit
until you perform one of the following actions:
• Turn the Campus Pager OFF.
• Press the CANCEL key.
If desired, press PAGE again to re-send the current message code.
5. Press CANCEL, then repeat Steps 3 and 4 if you want to transmit another
message code.
5.6 Receiving a Message Code with the Tone Pager
When a Tone Pager is turned ON and receives a page, it sounds 12 beeps and
flashes the received message code on its display, unless you press the
ON/OFF button to silence the pager before it finishes beeping. Press
ON/OFF to silence the pager when it beeps again, or the pager beeps once
about every 60 seconds to remind you that there is a new call.
Press ON/OFF to stop the pager from beeping every 60 seconds.
If the message code is transmitted to all pagers, each pager sounds the 12
beeps.
22
NOTE
Advertisement
Table of Contents
