Black Box FX810A-R2 Instructions Manual page 14

2. Insert the center-loaded antenna connector into the antenna jack on the
Campus Pager. Turn the connector clockwise until the antenna locks in
place. For maximum efficiency, extend the antenna to its full length,
orient it vertically, and keep it away from walls. See Figure 4-2.
Figure 4-2. Connecting the antenna to the Campus Pager.
3. Mark the positions for the two supplied mounting screws on the wall. The
positions should be 6" apart. Drill the two holes, then thread the two
screws into the wall. The screws should extend 3/16". Do not over-tighten
the screws.
4. Align the keyholes on the back of the brackets with the two screws, then
push in and press down to secure the Campus Pager to the wall. See
Figure 4-3.
CAMPUS PAGER
Clockwise
Back of
Campus Pager
13