Transmitting A Message Code To A Single - Black Box FX810A-R2 Instructions Manual

CAMPUS PAGER
3. Make sure that the Campus Pager is turned ON, then enter a 3-digit
pager code (000-999) and then 0.
4. Press the PAGE key on the Campus Pager, and the unit will transmit the
pager code to the pager. The pager will beep 5 times, and flash "L" on its
display, indicating that it received the message code 0.
For example, if you would like the pager to have a new pager code such
as 38, enter 380, and press PAGE.
After you press the PAGE key, the Campus Pager LED flashes the four digits
seven times, and simultaneously transmits the pager code to the pager. The
four digits will stay lit until you perform one of the following actions:
• Turn the Campus Pager OFF
• Press A/C or CANCEL
• Transmit a message to a pager
Perform the preceding steps for each pager used with the Campus Pager.
If the pager does not successfully store the pager code, repeat the
preceding steps.
5.4 Transmitting a Message Code to a Single Pager
1. Turn the Campus Pager power ON.
2. Press A/C or CANCEL if the display shows unwanted pager or message
codes.
3. Enter the three-digit code for the pager you want to receive the message,
then the one-digit message code that you want to send. If you enter the
wrong pager or message code, press A/C or CANCEL, then re-enter the
correct codes.
You cannot reset either of these codes after you press the PAGE button.
20
NOTE
NOTE
NOTE