Transmitting A Message Code To Groups Of System - Black Box FX810A-R2 Instructions Manual

4. Press the PAGE key. The TRANSMIT display lights during transmission,
and the pager's display flashes the message code number seven times. The
three digits will remain lit until you perform one of the following actions:
• Turn the Campus Pager OFF
• Press A/C or CANCEL
• Transmit a message to a pager
If desired, press PAGE again to re-send the current message code to the
pager.
5. Press CANCEL, then repeat Steps 3 and 4 if you want to transmit another
message code to another pager.
5.5 Transmitting a Message Code to Groups of System Pagers
1. Turn the Campus Pager power ON.
2. Press the CANCEL key if the display shows unwanted pager or message
codes.
3. Enter the 3-digit code for the group of pagers you want to receive the
message, then the 1-digit message code that you want to send.
The GROUP key represents 0-9 and can be inserted into any position of
this 3-digit code. This designates the specific group of pagers to receive
the message code. Example:
Press 10 GROUP (then message code)—sets the message code for pagers
numbered 100, 101, 102, 103, 104, 105, 106, 107, 108, 109.
Or, press 1 GROUP 0 (then message code)—sets the message code for
pagers numbered 100, 110, 120, 130, 140, 150, 160, 170, 180, 190.
Or, press GROUP 0 0 (then message code)—sets the message code for
pagers numbered 000, 100, 200, 300, 400, 500, 600, 700, 800, 900.
Or, press 0 GROUP GROUP (then message code)—sets the message code
for all pagers numbered 000 through 099.
Or, to page all pagers, press GROUP GROUP GROUP (then message
code)—sets the message code for all pagers numbered 000 through 999.
If you enter the wrong pager or message code, press the CANCEL key,
then re-enter the correct codes.
CAMPUS PAGER
21