Receiving A Message Code With The Vibrating/Tone; Reviewing Stored Message Codes - Black Box FX810A-R2 Instructions Manual

5.7 Receiving a Message Code with the Vibrating/Tone Pager
The Vibrating/Tone Pager has two modes of operation:
1. In the first mode of operation (tone mode), the pager beeps when it
receives a message. The pager sounds 12 beeps and flashes the received
message code on its display, unless you press the ON/OFF switch to reset.
Press ON/OFF to silence the pager when it beeps again, or the pager
beeps once about every 60 seconds to remind you that there is a new
message.
Press ON/OFF to silence the pager from beeping every 60 seconds.
If the message code is transmitted to all pagers, each pager sounds 12
beeps. Press ON/OFF to reset the pager.
2. In the second mode of operation (vibrating mode), the pager vibrates
when it receives a message. The pager vibrates for 3-1/2 seconds and
flashes the received message code on its display, unless you press the
ON/OFF switch to reset. Press ON/OFF to reset the pager when it
vibrates again, or the pager beeps once about every 60 seconds to remind
you that there is a new message.
Press ON/OFF to silence the pager from beeping every 60 seconds.

5.8 Reviewing Stored Message Codes

The pager can store eight message codes. Repeatedly press ON/OFF to view
the stored message codes one by one, from newest to oldest. A "-" indicates
the end of the stored message codes.
When the memory is full and a new message is received, the oldest message
code is deleted from memory.
If a newly received message code is identical to the last message received, it
is not stored.
All stored message codes are erased when you turn the pager OFF.
CAMPUS PAGER
23