Chevrolet LIGHT DUTY TRUCK (SERIES 10-35) Service Manual page 255

3B4-20 STEERING CO LUM NS
J -2 3 6 5 3
Fig. 3B4-26--R em oving Lock Plate Retaining Ring
5. Slide the directional signal cancelling cam, upper
bearing preload spring and thru st washer off the end of the
shaft.
6. Remove the directional signal lever screw and
remove the lever.
7. Push the hazard warning knob in and unscrew the
knob.
8. Remove the three switch m ounting screws.
All Columns
9. - Pull the switch connector out of the
bracket on the jacket and feed switch connector through
colum n support bracket and pull switch straight up, guiding
the wiring harness through the colum n housing and
protector.
10. Remove wire protector by pulling dow nw ard out
of colum n with pliers using tab provided (Fig. 3B4-27).
Tilt Column
- Position the direction signal and shifter
housing in the "low" position. Remove the harness cover
by pulling tow ard the lower end of the column, be careful
not to dam age the wires.
11. Remove the three switch m ounting screws and pull
the switch straight up, guiding the wiring harness and cover
through the colum n housing (Fig. 3B4-28).
Fig. 3 B 4 - 2 7 - - R e m o v i n g D ir ecti o n a l S ig n a l W i r e P ro te c to r
LIG H T T R U CK S ER V IC E M ANUAL
Fig. 3B4-28--Rem oving D irectional S ignal S w itch Assem bly
Installation
CAUTION: It is extremely important that
only the specified screws, bolts and nuts
be used at assembly. Use of overlength
screws could prevent a portion of the
assembly from
impact.
1. All except Tilt
- Be sure that the wiring harness
is in the protector. Feed the connector and cover down
through the housing and under the m ounting bracket
(column in vehicle).
Tilt
- Feed the connector down through the housing
and under the m ounting bracket. Then install the cover on
the harness.
2. Install the three m ounting screws and clip the
connector to the bracket on the jacket (Fig. 3B4-29).
3. Install the column to instrum ent panel trim plate.
4. Install the hazard warning knob and directional
signal lever.
5. Make certain that the switch is in "N eutral" and the
Fig. 3 B 4 - 2 9 - - l n s t a l l i n g S w itc h C o n n e c t o r O n to J a c k e t Clips
compressing under