Front Fender - Chevrolet LIGHT DUTY TRUCK (SERIES 10-35) Service Manual

2C-8 CHASSIS SHEET METAL
Fig. 2C-1 5 -R a d ia to r and G rille Brackets
10. Remove screws securing front fenders to radiator
support.
11. Remove screws securing fender skirts to radiator
support bottom. (Fig. 2C-18).
12. Remove bolt securing center grille support to
radiator support.
13. Remove bolts securing hood catch assembly to
radiator support.
14. Remove radiator support bolts secured to frame.
15. Tilt radiator support rearward and lift up and off.
Installation
1. Rotate radiator support into position and loosely
install attachments to frame.
2. Connect center grille support to radiator support.
3. Connect hood latch plate.
4. Connect radiator support brackets to fenders.
5. Connect support to fenders.
6 . Connect screws from underside of fender skirts to
support bottom.
7. Attach grille upper panel to fenders loosely.
8 . Attach grille lower panel to fenders.
9. Tighten radiator support bolts.
10. Place battery tray in position and fasten to radiator
support.
11. Install radiator coolant recovery tank hoses and
shroud.
12. Connect removed wiring to radiator support.
LIG H T TR U CK SERV ICE MANUAL
13. Install both head lamp assemblies.
14. Tighten all previously installed bolts and screws.
15. Install battery and connect leads and wires.
16. Install grille assembly.
17. Fill radiator with coolant as specified in Section 13.
18. Install hood on previously marked outline.
FRONT FENDER (FIG. 2C-19)
Removal
1. Remove hood and hinge assembly.
2. Remove head lamp bezel, wiring and attachments
from fender.
3. Remove screws attaching upper and lower radiator
grille panels.
4. Remove screws attaching fender wheel opening
flange to skirt.
5. Remove skirt to fender bolts, located inboard on
underside of skirt.
6 . Remove two (2) screws attaching support bracket to
fender.
7. Remove five (5) screws attaching radiator support
to front fender.
. Remove bolt and shim attaching trailing edge of
8
fender to hinge pillar.
9. Remove two bolts and shims at top rear of fender
attaching to cowl.
Installation
To install, reverse the removal procedure using sealing
tape between filler panel and fender. Check sheet metal
alignment.