2D-40
BODY
Fig. 2D -96--W indshield W ip e r Linkage
4.
Before installing wiper arms, operate wiper motor
momentarily which should rotate pivot shafts to park
position. Install arms.
COWL VENTILATOR GRILLE
Replacement
1. Remove windshield wiper arms.
2. Remove screws retaining grille, figure 2D-97.
3. Remove grille and seal.
4. Reverse above steps to install grille.
SIDE COWL VENTILATOR
Replacement
1. Remove screws retaining valve guide to panel, as
shown in figure 2D-98.
2. Remove valve assembly by depressing pins at top and
bottom of valve.
3. Reverse the above steps for installation.
Fig. 2D-97~Cowl V e n tila to r G rille
LIG H T T R U CK S ER V ICE MANUAL
Fig. 2D-98--Side Cowl V e n tila to r
REAR VIEW MIRRORS
Inside Rear V ie w M irro r
Replacement
The inside mirror may be removed by removing screw
retaining mirror to its glass-mounted bracket, and lifting
mirror off bracket (fig. 2D-99).
O utside Rear V ie w M irrors
Outside rear view mirror installations are shown in
figure 2D-100. Occasional tightening of mounting and
assembly bolts and screws will sharply decrease occurence
of failure due to door slamming or road shock.
Fig. 2D -99--lnside Rear V ie w M irro r