Chevrolet LIGHT DUTY TRUCK (SERIES 10-35) Service Manual page 185

2D-56 BODY
CAUTION: See CAUTION on page 1 of
this section regarding fasteners used on
seats and seat belts.
DRIVERS SEAT
Seat A d ju s te r
Replacement
1. Remove seat by removing nuts securing seat adjuster
to seat riser.
2. Remove adjuster from seat. See figure 2D-131.
3. Install seat adjuster to seat. Torque bolts to
specifications.
4. Install seat onto seat riser, and torque nuts to
specifications.
SEAT RISER
Replacement
1 . Remove seat and adjusters as an assembly by
removing nuts securing seat to riser.
2. Remove nuts securing seat riser to floor.
3. Install seat riser to floor.
specifications.
4. Install seat and torque nuts to specifications.
.04 MAX. CLEARANCE
IN SECONDARY LATCHED POSITION
IN FULL LATCHED POSITION.
LOWER
STRIKER A D JU S TM E N T
Fig. 2D-130--Rear Door S triker and W edge A djustm en t
SEATS
Torque nuts to
,010 TO .050 INTERFERENCE
UPPER STRIKER
ADJUSTMENT
,17 ± .0 3 (1 1 /6 4 DRILL)
IN SECONDARY
LATCHED POSITION
PASSENGER SEAT- MOUNTING BRACKETS
Removal
1. Remove seat and brackets from seat riser. See figure
2D-132.
2. Remove brackets from seat.
Installation
1. Install brackets to seat. Torque to specifications.
2. Install seat to seat riser. Torque to specifications.
SEAT RISER
Removal
1. Remove seat and mounting bracket as an assembly.
2. Remove riser from floor.
Installation
1. Install riser to floor. Torque nuts to specifications.
2. Install seat riser. Torque nuts to specifications.
REAR BENCH SEATS
All models equipped with 2nd, 3rd and 4th bench seat
assemblies feature a quick release mechanism which
facilitates removal of the seats for added cargo space.
Instead of the conventional clamp and bolt method of
seat retention, cam type latch assemblies and hooked
LIGHT TRU CK SER V IC E MANUAL