Chevrolet LIGHT DUTY TRUCK (SERIES 10-35) Service Manual page 186

Fig. 2D-1 32 -P assenger Seat
LIGHT TRU CK SERVICE MANUAL
retainers, which fit onto anchor pins in floor anchor plates
are used. When the latch assemblies are depressed, their
cams and the hooks of the retainers are drawn tightly onto
the anchor pins for secure seat attachment.
Removal is accomplished
procedure:
1 . Pull up on quick release latches located at lower
front of seat legs (right and left hand sides).
2. Tilt up front of seat and push seat rearward to clear
anchor pins located beneath floor at front and rear of seat
legs.
3. Lift seat up and remove from van.
4. To replace, reverse steps 1 to 3.
When replacing seats make sure that seat
NOTICE:
retainer hooks are fully engaged with anchor pins and
latching assembly is fully depressed into place.
SWIVEL BUCKET SEATS - G MODELS
Refer to the illustration in Figure 2D-134 for swivel
Bucket Seat Assembly installation.
ROOF VENT - G MODELS
Roof vent installation is illustrated in Figure 2D-135.
SERVICING LAP BELTS
Service precautionary items are outlined in the CK
portion of this section.
CAUTION: Internal drive thread-forming
anchor bolts are used to secure lap belts
to the floor pan. To remove or install
internal drive anchor bolts, use door lock
striker and lap belt anchor bolt removal
tool J-23457 or equivalent. Start bolt by
hand to assure that bolt is threaded
straight.
Refer to figures 2D-136 through 2D-138 and select the
appropriate illustration for removing and installing lap
belts.
BODY 2D-57
using the following