Chevrolet LIGHT DUTY TRUCK (SERIES 10-35) Service Manual page 154

Fig. 2D-67~Removing Torque Rod (16)
10. Refer to figure 2D-72 for window and regulator
installation.
11. Roll window to up position.
12. Disconnect sash from regulator as shown in figure
2D-73.
13. Remove glass from endgate.
14. Remove four regulator attaching screws and
withdraw regulator from endgate as shown in figure 2D-74.
15. Remove outside handle by removing nuts from
inside of outer panel. See figure 2D-61.
16. Reverse the above steps for reassembly.
ELECTRIC W IN D O W (16) MODELS
The window is controlled by a jackscrew mounted to
the regulator, drive cable and a 12V DC reversible motor
mounted to the endgate inner panel. This circuit also
includes a block out switch to prevent operation of the
window while the endgate is open (fig. 2D-75).
Service procedures for endgate disassembly are the
same as outlined above with the following exceptions:
Fig. 2D-69--Removing Side Latch
D rive Cable
The drive cable can be replaced by disengaging the
cable from the motor and jackscrew assembly and removing
the cable. Reverse removal procedure to reinstall cable.
M o to r (Fig. 2 D -7 6 )
Removal
1. Disconnect drive cable from motor.
2. Disconnect wiring harness from motor.
3. Remove (3) motor attaching screws and remove
motor.
4. To install, reverse removal procedure.
Blockout S w itc h (Fig. 2D -75)
Removal
1 . Disconnect L.H. side latch remote control rod from
center control by removing retaining clip.
2. Remove side latch retaining screws and disconnect
blockout switch wiring.
3. Remove side latch assembly and remove screws
retaining switch to side latch.
BODY 2D-25
LIGHT T R U CK SER V IC E MANUAL