Table of Contents
Advertisement
REAR DOORS (06 ONLY)
Adjustments
Rear doors may be adjusted in the body opening by
loosening hinge bolts and
retightening bolts. See figure 2D-54 for hinge bolt location.
Rear door wedges and strikers should be adjusted as shown
in figure 2D-55.
repositioning door,
then
Be sure that adjustments are as shown to insure proper
latching of the rear doors.
LOCKS, HANDLES AND RODS
The rear door lock, outside handle, lock cylinder,
control rods and latch are shown in figures 2D-51 and 2D-
52. The rods can be disconnected from the lock, latch or
handle by disengaging the retaining clips, as shown. The
lock cylinder is removed in the same manner as the front
side door lock cylinder.
REAR DOOR-Fig. 2D-54
Replacement
1. Remove bolts securing check arm bracket to body
pillar.
2. Remove upper and lower hinge bolts, and with aid
from an assistant, remove the rear door.
3. Reverse above steps for reinstallation.
REAR DOOR CHECK STRAP
M odel 0 6
Figure 2D-53 shows the cloth check strap used for rear
doors. The door may be completely opened by removing the
strap pin from the bracket. The bracket attaches to the pillar
with three screws; the strap is fastened to the door panel
with two screws and an attaching bar.
REAR DOOR CHECK ARM-FIG. 2D-54
Replacement
1. Remove bolts securing check arm bracket to body
pillar.
2. Remove check arm access cover.
3. With one hand supporting housing assembly and
insulator on the inside of the door panel, remove bolts
securing housing assembly to door.
4. Remove housing, insulator and check arm.
5. To separate check arm from bracket, remove holding
pin connecting the two parts.
6
. To install check arm, reverse the procedure above.
WEATHERSTRIP
Weatherstrip installation is shown in figure 2D-56.
Proper installation is dependent on completely cleaning all
foreign material from old installation and using a quality
cement on the new installation.
BODY
2 D -1 9
LIGHT T R U C K SER V IC E MANUAL
Hide quick links:
Advertisement
Chapters
Table of Contents
