Stationary Body Glass - Chevrolet LIGHT DUTY TRUCK (SERIES 10-35) Service Manual

primer will be applied (around edge of inside surface) by
wiping with a clean, alcohol dampened cloth. Allow to air
dry.
When cleaning windshield glass, avoid
NOTICE:
contacting edge of plastic laminate material (on edge
of glass) with volatile cleaner. Contact may cause
discoloration and deterioration of plastic laminate by
wicking action. DO NOT use a petroleum base solvent
such as kerosene or gasoline. The presence of oil will
prevent adhesion of new material.
. Apply blackout primer to the same area of the
6
windshield glass that was cleaned in the previous step and
is shown in View C. Allow to dry to touch.
7. Apply a 3/16 inch minimum diameter bead of
urethane adhesive around pinch-weld flange as shown in
View B. Windshield glass must be installed within 20
minutes after performing this step.
8 . Apply a mist of plain water to the urethane bead on
the pinch-weld flange, wetting it fully.
9. Install rubber weatherstrip to the pinch-weld flange.
10. Apply a 3/16 inch minimum diameter bead of
urethane adhesive to rubber weatherstrip glass channel as
shown in View D.
11. Apply a mist of lubricant to surface
weatherstrip as shown in View D, wetting it fully. Install
windshield within 5 minutes after performing this step.
V I E W
tape pigtail of antenna to inside surface of windshield glass
in a convenient and accessible position.
opening. Suction cups may be used but are not mandatory.
Then, install glass in channel of weatherstrip.
must be seated prior to application of lubricant.
lockstrip in channel of weatherstrip. Install lockstrip cap at
lockstrip joint.
connect antenna pigtail to radio antenna lead.

STATIONARY BODY GLASS

Replacement
be applied to other stationary glass, such as shown in figures
2D-20 and 2D-21. Remember to check for cause of
breakage, and to always wear gloves when handling glass.
"C" or
Installation procedures are similar to G-Van windshield.
Refer to figures 2D-101 and 2D-103, later in this section.
Fig. 2D -1 8 ~ W i n d s h i e l d In s ta l la tio n -C K T r u c k
12. On windshields equipped with embedded antenna,
13. With the aid of a helper, lift glass into window
14. Apply lubricant to lockstrip channel. Windshield
15. Use J-2189 weatherstrip tool set and install
16. Install windshield wiper arms and blades.
17. On windshields equipped with embedded antenna,
18. Install inside trim panels.
19. Install rear view mirror to windshield.
The method used to remove the windshield glass may
O U T SID E O F GLASS
B LA C K O U T P R IM E R
IN SIDE SU R F A C E
O F GLASS
C LE A N E R -
V I E W
BODY 2D-9
LIGHT T R U CK SER V IC E MANUAL