Chevrolet LIGHT DUTY TRUCK (SERIES 10-35) Service Manual page 176

FUSE
PA NEL'
Fig. 2D-1 13~Power W in d o w and Power Door Lock W irin g
N O TE
assembled to lock asm before
lock asm is installed to door.
V I E W
Fig. 2D -1 1 4 - L o c k an d R e m o te Con tr ol A s s e m b ly
RELAY
W IT H P O W E R
W IN D O W S
C IR C U IT
BREAKER
W IT H P O W E R
' LO CKS
d o o r
V IE W
Rod and clip must be
| VIE W
REMOTE CONTROL AND CONNECTING
ROD-Fig. 2D -114
Replacement
1 . Raise door window and remove door trim pad.
2. Remove bolts securing remote control to door inner
panel.
3. Pivot remote inboard
connecting rod, and remove remote control from door.
Connecting rod can be removed at this point by
disconnecting spring clip from lock.
4. To install, reverse removal procedure.
POWER DOOR LOCKS
The power door lock system incorporates a motor
actuator in each door which actuates the lock through
linkage (fig. 2D-116). See Figure 2D-113 for switches, relay
and wire routing.
Replacement
1 . Disconnect battery ground cable.
2. Remove door trim panel to gain access to power door
lock motor.
3. Disconnect electrical connector from motor.
4. Remove screws attaching motor to door inner panel.
5. Remove door lock lever from rubber mount at top
of motor actuator and remove motor through access hole.
6 . To install, reverse steps 1 through 5 above.
BODY 2D-47
W I N D O W RELAY
slightly, to disengage
LIGHT TRUCK SER V IC E MANUAL