Table of Contents
Advertisement
3.
Frag Threshold
This value should remain at its default setting of 2346. The range is 256-2346
bytes. It specifies the maximum size for a packet before data is fragmented into
multiple packets. If you experience a high packet error rate, you may slightly
increase the Fragmentation. Setting the Fragmentation too low may result in
poor network performance. Only minor modifications of this value are
recommended.
4.
SSID
Wireless network name, it is selected AP name in Quick Setup.
5.
bg Mode
This field indicates the 802.11g interface mode. "802.11g" prevents the 802.11b
clients from accessing the router. "bg Mixed" allows both 802.11b and 802.11g
clients to access the router. "802.11b" will enable the network as an 802.11b
wireless network. By default, the Mode is "bg Mixed".
6.
Rate
Select the transmission rate for the network. The default setting is Auto.
7.
Channel
IEEE 802.11g and 802.11b devices are direct sequence spread spectrum
devices that spread a radio signal over a range of frequencies. The range of
frequencies used by a direct sequence device is called Channel.
The 802.11g and 802.11b specification supports up to 14 overlapping Channels
for radio communication. To minimize interference, configure each WE-1120 to
use Non-overlapping channels. Non-overlapping channels have 25 MHz
separation beginning at the first allowed channel for the country (for the US and
most of Europe, channel 1, 6 & 11 are used.).
8.
Specify an IP
Input the IP address, Subnet Mask, Gateway and DNS.
9.
Encryption
Include Open System, Shared Key, TKIP and AES.
Open System & Shared Key
WEP Key
208
Advertisement
Table of Contents
