Installation; What You Will Need - ADDER AVMP4-SP Installation And Use Manual

2. Installation

2.1 What you will need

Cables to connect the AdderView MP to each of your computers. These cables
are specially constructed for use with the AdderView MP and may be purchased
from your AdderView MP supplier. Cable specifications and part codes are given in
appendix A.
A suitable keyboard. Supported types are:
1) A Sun keyboard with an 8 pin mini-DIN connector (recommended if you are
going to connect any Sun computers to the MP).
2) A standard PC style keyboard with a 6 pin mini-DIN PS/2 style connector.
3) A standard PC style keyboard with a 5 pin DIN connector and an AT to PS/2
keyboard adapter (5 pin DIN to 6 pin mini-DIN)
A suitable mouse. If you wish to use the mouse to switch the AdderView MP's
channel then you will need a three button mouse or an IntelliMouse. Supported
types are:
1) A standard PC style two or three button Microsoft or Logitech compatible
mouse or a Microsoft IntelliMouse compatible mouse with a 6-pin mini-DIN
connector.
2) A Sun mouse of the type that plugs into the Sun keyboard. This should have
an 8 pin mini-DIN connector.
A monitor with a standard VGA/SVGA (15 pin) connector that will work when
connected directly to each of your computers. AdderView MP supports low and high
resolution monitors. If you have a monitor with a 13 pin 13W3 connector of the type
that was traditionally used to connect to older Sun computers then you will need an
adapter to convert this to the 15 pin format - please contact your AdderView MP
supplier.
AdderView MP Installation and Use Page 11