Installing The Dcs And Da In The Appliance Cabinet - Honeywell X-618 Installation Manual

Figure 6 Schematic Diagram of Cabinet Grounding

Installing the DCS and DA in the Appliance Cabinet

Install the DCS and DA into the associated appliance cabinet. This process is described in the
following steps:
1. Connect and hang the emergency microphone in place on the front panel of the DCS. An
installed emergency microphone is shown in Figure 7.
Figure 7 PTT Microphone Installation Diagram
2. Install brackets on the left and right sides of the DCS, as shown in Figure 8.
Figure 8 Schematic Diagram of the DCS Bracket Installation
3. Put the DCS appliance into the cabinet, and tighten the screws to secure the unit, as shown in
Figure 9.
9