Connecting The Sound Source Equipment To The Dcs; Connecting The Dcs To The Da - Honeywell X-618 Installation Manual



Connecting the DCS to the DA


Connecting the DCS to the NPM

Connecting the Dry Contacts (Optional)

Connecting the Dry Contacts (Optional)

Connecting the Noise Detector (Optional)

Connecting the Sound Source Equipment to the DCS

Connect the external sound source equipment to the DCS appliance as necessary.
Figure 10 Schematic Diagram of Connecting the DCS External Sound Source Equipment
Connecting the DCS to the DA
Note：
The DCS can be connected to the power amplifier in the following configurations:

Connect the PA1/2 and PA2 port of the single-channel power amplifier to the DCS control port
using two network cables.

Connect the PA1/2 port of the two-channel power amplifier to the DCS control port using one
network cable. Refer to Figure 11.

Connect the PA1/2 and P3/4 port of the four-channel power amplifier to the DCS control port
using two network cables.
1. Connect the DA RJ45 port to the DCS control port using the audio input lines that are included
in the package containing the DA, as shown in Figure 11.
Figure 11 Connecting the RJ45 Audio Cable to the DCS and DA
11