Connecting The Protective Grounding Appliance Wires; Connecting The X-618 System Components - Honeywell X-618 Installation Manual

Figure 9 Schematic Diagram of Installing the DCS in the Cabinet
4. Install brackets on the left and right sides of the DA, as shown in Figure 8.
5. Install the DA appliance into the cabinet, and tighten the screws to secure the unit, as shown
in Figure 9.
Note:
1U (1U=44.45mm) of space is required right above the DA to allow for proper appliance ventilation.
It is recommended to use an empty panel to close and open the installation space of the cabinet.

Connecting the Protective Grounding Appliance Wires

The DCS and DA grounding terminals must be connected to the terminal blocks through flexible
cables with a cross-section of 1.5mm
Notice:
Do not connect the grounding output cable with the grounding input cable as a short circuit can
occur.

Connecting the X-618 System Components

This section describes the connections between the following X-618 system components:

Connecting the Sound Source Equipment to the DCS
10
2
within the cabinet, as shown in Figure 6.