Installation Inspection; Inspection - Honeywell X-618 Installation Manual

Figure 26 Schematic Diagram of the NPM Power Supply Cable Connection

4 Installation Inspection

This section describes conducting a series of inspections after completing the system installation
procedure so as to ensure that the installation was done correctly.

Inspection

Inspect the following items after installing the X-618 system and before turning the system on:

Check if sufficient heat ventilation space is left above the DA appliance.

Check the protective grounding cables to make sure they were correctly connected.

Check the consistency of the power supply to which the power supply cables are connected.

Check the connection relationship between system components for correctness.
20