Ftp Settings - D-Link SecuriCam DCS-5300W Manual

Using the DCS-5300W with an Internet
browser (continued)
Configuration > Advanced > Mail & FTP (Continued)

FTP Settings

Local FTP server port -
1st FTP server -
1st FTP user name -
1st FTP password -
1st FTP remote folder -
Primary FTP Passive
Mode-
It can be other than default port 21. If you find that
you want to change the port to a port number
other than 21, you will need to specify the port
when connecting to the FTP server. For example
FTP://68.5.1.81:60 (if you are to use port 60 for
your FTP server port)
The domain name or IP address of the external
FTP server. The following user settings must be
correctly configured for remote access.
Granted user name on the external FTP server.
Granted password on the external FTP server.
Granted folder on the external FTP server. The
string must conform to the external FTP server.
Some FTP servers cannot accept a preceding
slash symbol before the path if there is no virtual
path mapping. Refer to the instructions of the
external FTP server for details. The folder privilege
must be open for upload.
If the DCS-5300W is located inside a network that
is protected by a firewall, a data connection for
FTP may be prohibited. Passive mode FTP can
bypass this rule and allow the uploading of
snapshots. If the passive mode is selected, the
DCS-5300W can automatically attempt to upload
in active mode if the external FTP server does
not support passive mode.
37