Page 1
Technical Support Setup Procedure How to: Change the SSID and Enable to WEP Encryption. Step 1: Connect the power of the camera and connect LAN cable from the camera to your router. Step 2: Run the CD that come with the camera on your computer. Step 3: Click on next Step 4: Put a tick in the box beside ‘I accept these terms and conditions.’...
Page 2
Technical Support Setup Procedure Step 5: Click on Next Step 6: Click on Next Page | 2...
Page 3
Technical Support Setup Procedure Step 7: Click on Next Step 8: Click on Next Step 9: Click on Yes. Page | 3...
Page 4
Technical Support Setup Procedure Step 10: Copy down the IP address of the DCS-5020L show in the list. Step 11: Open Internet Explorer and enter the IP address of the camera that you had copy down on the URL bar.
Page 5
Technical Support Setup Procedure Step 14: Tick on the Enable Wireless. Click on Site survey. Step 15: Select the Wi-Fi network name you want to connect to Step 16: Under Wireless Configuration. a) Select Shared for Authentication b) Select WEP for Encryption c) Select 1 for Default Key d) Enter the wireless password used on your AP or Wireless Router in Key 1.
Need help?
Do you have a question about the DCS-5020L and is the answer not in the manual?
Questions and answers