Table of Contents
Advertisement
I N S T A L L A T I O N
An identification tag is permanently mounted
1.
on the dump station.
D
ENSURE POWER SOURCE
MATCHES VOLTAGE STAMPED
ON APPLIANCE NAMEPLATE.
Plug the unit into a properly grounded
receptacle ONLY. Arcing will occur when
2.
connecting or disconnecting the unit unless
power switch is in the "OFF" position.
Position the unit so the cord is easily
3.
accessible in case of any emergencies. If
necessary, a proper receptacle or outlet
configuration as required for the unit must be
installed by a licensed electrician in
accordance with applicable, local electrical
codes.
D
ELECTRICAL CONNECTIONS MUST
BE MADE BY A QUALIFIED SERVICE
TECHNICIAN IN ACCORDANCE WITH
APPLICABLE ELECTRICAL CODES.
N G E R
N G E R
ELECTRICAL • ASF-60DS & ASF-75DS
VOLTAGE PHASE
CYCLE
120
1
60
230
1
50
F r y e r D u m p S t a t i o n O p e r a t i o n & C a r e M a n u a l • 8
230V:
To prevent an electrical shock hazard between
the appliance and other appliances or metal
parts in close vicinity, an equalization-bonding
stud is provided. An equalization bonding lead
must be connected to this stud and the other
appliances / metal parts to provide sufficient
protection against potential difference. The
terminal is marked with the following symbol.
NOTE: The appliance must be connected to an
electrical circuit that is protected by an
external GFCI outlet.
/
kW
HZ
AMPS
CORD
8.4
1.0
15A-125
4.4
1.0
16A-250
D
N G E R
To avoid electrical shock, this
appliance MUST be adequately
grounded in accordance with local
electrical codes or, in the absence of
local codes, with the current edition
of the National Electrical Code
ANSI/NFPA No. 70. In Canada, all
electrical connections are to be
made in according with CSA C22.1,
Canadian Electrical Code Part 1 or
local codes.
&
PLUG
5-15P
NEMA
V PLUG
8'
CORD
7/7
CEE
V PLUG
9'
CORD
Advertisement
Table of Contents
