Built In Tests; Software Version; Voltage; Current Consumption - Menvier Security TS2500 Installation & Programming Manual

Engineers Menu 3

Built In Tests

The TS2500 system has the following diagnostic routines:
9
Engineers menu 3
Built in tests
Panel version is
TS2500 - Ver 2.0
1
Voltage 13.60V
2
Current 1084mA
3 [ENT] to view :-
Cct resistance
[ENT] to test :-
4
C
digicom outputs
A
5
[ENT] to test :-
Panel outputs
6 [ENT] to test :-
Node outputs
7 [ENT] to CONFIRM
Network devices
8 [ENT] to test :-
Keypad display
9 [ENT] to view :-
Network devices
[ENT] to view :-
Network errors
[ENT] to do
False setting
[ENT] to test :-
digicom channels
Built In test Menu Flowchart

Software Version

When selecting the built in tests routine the software
version is displayed until you select one of the other
diagnostic routines.

Voltage

When this test option is selected the battery charging
voltage at the control panel is displayed, the accuracy
of this measurement is ± 0.2V.

Current Consumption

When this test option is selected the total current
consumption for the system is displayed, the accuracy
of this measurement is ± 50mA.
68
[3-9]
[

View Circuit Resistance

When this test routine is selected the resistance for each
detection circuit may be measured, the accuracy of
this measurement is ± 0.1 KOhms.
[ENT] to view :-
3
Cct resistance
Device type
TSLEC8
Circuit No.
0001 2K2
A = Next circuit
C = Previous circuit
View Circuit Resistance Flowchart

Test Digicom outputs

This test routine allows the engineer to test all eight
digicom outputs on the main control panel PCB.
[ENT] to test :-
4
Digicom outputs
Digi outputs on
1 * 3 * * * * *
1 8 -
Test Digicom Outputs Flowchart

Test Panel outputs

This test routine allows the engineer to test the four
control panel outputs.
[ENT] to test :-
5
Panel outputs
Panel outputs on
1 4 -
Test Panel Outputs Flowchart
TS2500 Installation Manual
[
Resistance
]
[
Outputs
*=off
to toggle outputs
]
[
Outputs
1 * 3 4
*=off
to toggle outputs
]