Honda VT750DC ACE
Step 11: Put it all back together!:
Now that the valve clearances have been checked and adjusted, you can start putting everything back together.
Just go in reverse of the instructions above and take note of the following...
•
Clean the gasket surfaces on the cylinder heads before re-installing the covers
•
Put a little grease on the threads of the crankcase hole and timing hole caps
•
Make sure you route the choke cables properly as you insert the carbs
•
Make sure you tighten the carb drain screws before opening the fuel valve
•
You lose a little oil from the heads, check the level after you run it
•
If you had to disconnect the coolant lines to get the head covers off, make sure you check the coolant
level after running the bike.
40
Service Interval and Recommended Maintenance Manual