Route Guidance - Mercedes-Benz COMAND control panel Operating Instructions Manual

Please always use this feature instead of
consulting the map display for directions.
Consulting the symbols or map display for
directions may cause you to divert your
attention from driving and increase your risk
of an accident.
i
Audible navigation announcements are
muted during a telephone call.
If you have missed an announcement, you can
call up the current announcement at any
time.
To show the menu: press W the COMAND
X
controller.
Select + in the navigation system menu
X
bar by turning cVd the COMAND
controller and press W to confirm.
Switching navigation announcements
on/off
To switch off: press the B button during
X
an announcement.
You will briefly see the message:
driving instructions have been
muted.
To switch on: press W the COMAND
X
controller.
Select + in the navigation system menu
X
bar by turning cVd the COMAND
controller and press W to confirm.
i COMAND automatically switches the
navigation announcements back on when:
you have a new route calculated.
R
you switch COMAND back on again or
R
start the engine.
Reducing volume during a navigation
announcement
The volume of an active audio or video source
can be automatically reduced during a
navigation announcement.
Select Navi
X
sliding ZV and turning cVd the COMAND
controller and press W to confirm.
Select Audio Fadeout
X
confirm.
Depending on the previous status, the
function is switched on O or off ª.
Setting the volume manually
Adjust the volume using the q control
X
knob during a navigation announcement.
or
Select + in the map view with the menu
X
shown and adjust the volume using the
q control knob.
Avoiding a section of the route
blocked by a traffic jam
This function blocks a section of the route
ahead of you. You can set the length of the
blocked route section. If possible, COMAND
The
calculates a detour around the blocked
section of the route.
To switch on navigation mode: press the
X
g function button.
To show the menu: press W the COMAND
X
controller.
Select Route
X
menu bar by turning cVd the COMAND
controller and press W to confirm.
Select Detour
X
To block a section of the route: select
X
Longer or
using W until the desired section has been
selected.
i
The total length of the section that can be
blocked is defined by the digital map. The
menu items are available accordingly.
To start route calculation: select
X
and press W to confirm.

Route guidance

in the main function bar by
and press W to
in the navigation system
and press W to confirm.
Shorter repeatedly and confirm
71
Start
Z