IBM System/34 Maintenance Manual page 526

'-- .
-----)
..,--.
I
'-/
J
45-400 LINE PRINTERS AND DATA
COMMUNICATIONS CABLES
If the System/34 that you are installing does not have a
line printer or data communications, go to paragraph
45-500.
45-405
IBM 3262 Printer
If the System/34 that you are installing does not have a
3262 Printer, go to paragraph 45-410.
1.
2.
Unpack and install the 3262 Printer as described in
the 3262 Printer unpacking and installation
instructions.
Remove the cable tower cover and connect the
3262 Printer I/O cables and the ground strap to
the cable tower as shown in Figure 45-6. Do not
install the cable retainer until all cables are
attached to the cable tower.
3. Verify that the jumpers on the 3262 adapter cards
(A-A2T2 and A-A2U2) are in the correct locations
for the printer being installed. (See paragraph
08-500.)
4. If the System/34 that you are installing does not
have data communications, install the cable
retainer and reinstall the cable tower cover (Figure
45-6).
5. Go to paragraph 45-500.
·45-400
45-410 IBM 5211 Printer
If the System/34 that you are installing does not have a
5211 Printer, go to paragraph 45-420.
1.
2.
3.
4.
5.
Unpack and install the 5211 Printer as described in
the 5211 Printer unpacking and installation
instructions.
Remove the cable tower cover and connect the
5211 printer I/O cables and the ground strap to
the cable tower as shown in Figure 45-6. 00 not
install the cable retainer until all cables are
attached to the cable tower.
Verify that the jumpers on the 5211 adapter card
(A-A2T2) are in the correct locations for the printer
being installed. (See paragraph 07-500.)
If the System/34 that you are installing does not
have data communications, install the cable
retainer and reinstall the cable tower cover (Figure
45-6).
Go to paragraph 45-500.
45-420 External Modem EIA/CCITT
If the System/34 that you are installing does not have
an external modem, go to paragraph 45-430. If the
System/34 that you are installing has an MLCA
(multiline communications adapter), go to step 2.
1. Attach the communications cable to 0- 87 (line 1)
or to 0- 86 (line 2) as shown in Figure 45-6. The
other end of the cable is to be attached later. Go
to step 3.
2.
3.
4.
Attach the communications cable to 0- 86-1 (line
1), 0-86-2 (line 2), 0-87-1 (line 3), or 0-87-2 (line
4) as shown in' Figure 45- 7. The other end of the
cable is to be attached later.
If this is the last communications line to be
installed, install the cable retainer and reinstall the
cable tower cover (Figure 45-6).
Go to paragraph 45-430.
Installation Instructions 15
-