IBM System/34 Maintenance Manual page 315

27-305 CARRIAGE BED TO DISKETTE DRIVE
BEZEL ADJUSTMENT
1. Place the 72MD unit in the service position (see
paragraph 27-205).
2.
Place I/O slot 1 at the center of the drive beze/.
3.
Loosen the four carriage bed screws
4)
and slide
the carriage bed
E)
away from the bezel
G.
4. Install the adjusting tool. (part 2462583 for old
style picker, part 2462612 for new style picker)
into I/O slot 1 with the second adjusting surface
G
of the tool touching the carriage bed
E).
5. Slowly move the bed
E)
toward the bezel
G
until
the other end
0
of the tool. touches the drive
bezel
G.
6. Tighten the four carriage bed screws
4).
7. Return the 72MD unit from the service position
(see paragraph 27-205).
27-310 CARRIAGE BED TO DISKETTE DRIVE
BEZEL SERVICE CHECK
1. Place the 72MD unit in the service position (see
paragraph 27-205).
2.
Place I/O slot 1 at the center of the diskette drive
bezel.
3. Slowly lower the adjusting tool. (part 2462583
for old style picker, part 2462612 for new style
picker) into I/O slot 1 so that the second adjusting
surface
G
touches the carriage bed
E).
4. Check that the .other end
0
of the tool.
touches the drive bezel
G.
If it does not, perform
the carriage bed to diskette drive bezel adjustment
(see paragraph 27-305).
II
2482$83 "
o
0 Dr-----,
~==============~----~
o
"2462612
Jj
o
0 0-------.
30
27-305
/
'
"
..... .
,-----
/
I
\"