IBM System/34 Maintenance Manual page 129

10-140 TERMINATOR CARD
I
Note: On systems with more than one disk, the
terminator card is located in the last drive.
Removing the Terminator Card
1. Set Power to 0 (operator panel).
2. Remove the two cable clamp screws
0
and
remove the cable clamp and the attached card
gate cover
O.
3.
Remove the terminator card from A4.
22
Reinstalling the Terminator Card
1.
2.
10-140
Plug the terminator card into A4.
With the cables in position, use the two screws
0
to reinstall the cable clamp and the attached cover
O·
"
.
,/---.....
/'.~,
I
I,\", .'