10-120
SHOCK MOUNTS
Removing the Shock Mounts
CAUTION
Do not remove more than one shock mount at a time
unless the disk enclosure has been removed.
1.
2.
Set Power to 0 (operator panel).
Turn screw
e
counterclockwise and open the card
gate.
3.
Turn the actuator lock knob. clockwise (through
120 degrees) until the actuator lock reaches its
stop.
4.
Remove the four sets of
screws.,
washers
CD,
and nuts
G
and remove the single screw. and
washer
G.
5.
Remove the shock. mount
G.
Reinstalling the Shock Mounts
1.
Slide the shock mount
G
into position.
2.
Reinstall and tighten the single screw. and
washer
G
and the four sets of screws . '
washers
CD,
and nuts
G.
3.
Turn the actuator lock knob. counterclockwise
(through 120 degrees) until the actuator lock
reaches its stop.
4.
Close the card gate and tighten the screw
e.
18
10-120